5/26/2023 0 Comments Tera term send break not working![]() The ending can be configured from the setup/terminal menu, and (if enabled in setup/additional_settings/copy_and_paste menu) the mouse's right or mid clicks can be also used. ![]() Write the command in your favorite editor, like PN2, Notepad++, etc., (or even TT itself in a separate terminal, not connected to your target board) copy it with ctrl+c or whatever, and then switch to TT and press either alt+v or alt+r to send it out without, respective with, a CRLF ending (see the edit menu in TT/VT). If for any reason you are restricted to TT, then you can use the following trick: If that is your case, you have to use another terminal program (there are plenty available). When you type "test", unless you are lightning fast, four frames will be sent. This is because the USB sends "frames" with each character you type, and the device expects to receive a "full command" in a frame, if the frame is not a valid command, is discarded. For example, many USB devices which use USB-to-serial internals (like ST development tools and MCUs). Some devices receive the commands in a buffered way and have a short timeout between the characters, so you are never able to "type" a command in TT. ![]() If anything is sent with each character, this is configurable, but there is no way to configure TT in such a way to "send nothing" until you type 'enter', as other "terminals" do. ![]() When typing characters into TT, the characters are sent out as you type them, and there is no way to configure it otherwise.
0 Comments
Leave a Reply. |